Try to disconnect and reconnect both USB and power cables to the eZdsp, and then run the CCS again. It worked for me! Sorry, I don't know why.

Yeu-Shyr
Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467

Hello everyone,

We have installed drivers for F2808 eZdsp from Spectrum
Digital into folder where CCStudio is located. Then we
start Setup CCStudio v.3.1 where we first have to add
board. We do so, and add F2808 eZdsp board and do save&quit
dialog. After that we are promted to start CCStudio and we
do that but there appears error :
-----------------
Error initializing emulator

I/O PortT0
Board Name: F2808 eZdsp
Cpu Name: cpu_0

Abort: Close Code Composer Studio
Retry: Try to initialize the emulator again
Ignore: Ignore the initialization error and start
potntionaly without target debugging access.
Diagnostic: Run diagnostic utility
-----------------

The only time without error is when we select F2812 Device Simulator
and then we can obtain code from RTW in Matlab. There isn't device
simulator for F2808 avilable. We want to set everything right before
we try running RTW with Target for TI C2000 in Matlab2007b.

Is there any known incompatibility problem for f2808 eZdsp
and CCstudio?

What could be wrong here?

Please,help.
Thank you.

P.S. We are not hardware engineers, but just want to implement Matlab
model of arc furnace on a DSP, using TI 2000 blockset and our
simulink model.

Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467