Reply by "Tommy S. Hancock"●January 8, 20082008-01-08
I too think you should look in the linker or hex conversion command file, .cmd.
Our board, which is based on a 6412, has worked amazingly well in the area of
boot loading.
The .out is converted to a .ascii using hex6x.exe. hex6x.exe command input is a
.cmd file. This program makes an ascii file. When you view the .ascii it should
make a little bit of sense to you. In ours, there are only two viewable
addresses, x90000000 and x90000500, the boot loader address and the application
address in the FLASH respectively. It does take a bit of practice to get a good
balance between what the linker can do and what hex6x.exe can do – as far
as making a module for FLASH programming.
A big difference between your application and ours though is that our FLASH is
programmed by a PC through the PCI interface.
I only had spra999a.zip available and the FLASHBURN was incomplete at best. I
just took the actual FLASH programming steps and put them in the PC. Is
FLASHBURN a completed product in spra999a1.zip?
Reply by christophe blouet●January 6, 20082008-01-06
Hello,
is that a linker error? or is it a flashburn error ?if it's first one,
looks like you have declared 2 sections Flash_boot.
Regards
Reply by Richard Williams●January 6, 20082008-01-06
z_1151,
I suspect the problem is in the linker .cmd file.
Please paste that file into your next yahoo post.
R. Williams
---------- Original Message -----------
From: z...@yahoo.com
To: c...
Sent: Sat, 05 Jan 2008 08:21:08 -0500
Subject: [c6x] bootloader for flash bootloading
> Hi
> I'm trying to build a project that programmed in flash by flashburn with
C6713.
> For this case, I followed SPRA999A1 in my project. But it is not
successful.
> For example error is
>
> "Flash_boot and Flash_boot in page 0 have overlap."
>
> I couldn't find its reason.
> Also:
> I opened an example of SPRa999a1.Zip file then I delete source files and add
my source
> files and a bootloader code. CCS had error: couldn't open some header
file.
>
> I use simulink and CCS.
> Thanks for any help that I have a building a project that programmed by
flashburn and
> execute on C6713 successfully
>
> Regards
> Zahra ------- End of Original Message -------
Reply by z_11...@yahoo.com●January 5, 20082008-01-05
Hi
I'm trying to build a project that programmed in flash by flashburn with
C6713.
For this case, I followed SPRA999A1 in my project. But it is not successful.
For example error is
"Flash_boot and Flash_boot in page 0 have overlap."
I couldn't find its reason.
Also:
I opened an example of SPRa999a1.Zip file then I delete source files and add my
source files and a bootloader code.
CCS had error: couldn't open some header file.
I use simulink and CCS.
Thanks for any help that I have a building a project that programmed by
flashburn and execute on C6713 successfully