vijaykumar1981 wrote:

> Hi,
>      I am using XDS510 USB PLUS JTAG Emulator for programming flash inside
> TMS320F2810. Currently I am achieving this by selecting "Tools->F28XX
> On-chip Flash programmer" option from code composer studio. I am planning
> to automate programming. I think I can use command line arguements for
> programming through DOS prompt. I didn't find any help over programming
> through command line for XDS510 USB PLUS JTAG Emulator.
> Any help to resolve the issue is highly appreciated.

Don't need any of that stuff.

Load the flashloader by the bootloader procedure, then program the flash 
via RS-232. That's all it takes.


Vladimir Vassilevsky
DSP and Mixed Signal Design Consultant
http://www.abvolt.com

On Thu, 17 Jul 2008 13:54:49 -0500, "vijaykumar1981"
<vijay1981@email.com> wrote in comp.dsp:

> Hi,
>      I am using XDS510 USB PLUS JTAG Emulator for programming flash inside
> TMS320F2810. Currently I am achieving this by selecting "Tools->F28XX
> On-chip Flash programmer" option from code composer studio. I am planning
> to automate programming. I think I can use command line arguements for
> programming through DOS prompt. I didn't find any help over programming
> through command line for XDS510 USB PLUS JTAG Emulator.
> Any help to resolve the issue is highly appreciated.
> Thanks,
> Vijay
> 
http://focus.ti.com/dsp/docs/dspplatformscontento.tsp?sectionId=2&familyId=1406&tabId=2026#guisdf

http://emulators.spectrumdigital.com/utilities/sdflash/

It is GUI, not command line, but does not require use of Code Composer
Studio.

-- 
Jack Klein
Home: http://JK-Technology.Com
FAQs for
comp.lang.c http://c-faq.com/
comp.lang.c++ http://www.parashift.com/c++-faq-lite/
alt.comp.lang.learn.c-c++
http://www.club.cc.cmu.edu/~ajo/docs/FAQ-acllc.html

Hi,
     I am using XDS510 USB PLUS JTAG Emulator for programming flash inside
TMS320F2810. Currently I am achieving this by selecting "Tools->F28XX
On-chip Flash programmer" option from code composer studio. I am planning
to automate programming. I think I can use command line arguements for
programming through DOS prompt. I didn't find any help over programming
through command line for XDS510 USB PLUS JTAG Emulator.
Any help to resolve the issue is highly appreciated.
Thanks,
Vijay