Do the following:
for the input samples/data to the encoder.
for(i=0;i
inp_buf[i]=(0x3FFF & (inp_buf[i]>>2));
and after decoding i.e. at the decoder data which I assume goes in out_buf:
for(i=0;i
out_buf[i]=out_buf[i]<<2;
I hope it will give you the correct decoded outputs. here input should be 16 bit
pcm if U are using ITU code. Anyway you can see in the code what format it
needs? Its very simple....
Sanjeev
________________________________
From: s... [mailto:s...] On Behalf Of wu xudong
Sent: Wednesday, July 26, 2006 7:30 AM
To: s...
Subject: Re: [speechcoding] G726 testing
Maybe 16 bit is OK.16 bit per sample means the raw
data.and G.726 should deal with it.I think it's no
need to tranfer input to A-law or u-law.
--- v...@yahoo.co.in $B
> Hi All,
> I am using reference G.726 code of ITU software tool
> library. I am now testing the code using VC++. It is
> said that the reference code takes A-law or Mu-law
> coded input and outputs the same, but the code takes
> 2 bytes of input( short ) and A-law coded should be
> one byte. I am getting wrong output. can any one
> help in this regard??
>
> Regards,
> Vijay