Most probably the best for you is to use McBSP to do it.

There is no sync signal? this is all Async?

Regards Start a New Thread

So this is probably a really stupid question but I am completely new
to DSPs so not entirely sure what I am doing.
I am working with a TI TMS320C6713 DSK from Spectrum Digital
currently but will eventually be switching over to a TMS320C6720. I
have this embedded graphics controller that I want to talk to from my
DSP. The embedded graphics controller on accepts simple TTL serial
commands using only TX and RX signals. So my question is how do I
send simple TX and RX commands from my DSP to this device? I don't
think it should be hard at all but I can't find any information on how
to do it! Any help would be greatly appreciated! Thanks!

Check Out Industry's First Single-Chip, Multi-Format, Real-Time HD Video Transcoding Solution for Commercial & Consumer End Equipment: www.ti.com/dm6467 Start a New Thread