Section 11.5.2 states that the PWM peripheral runs off the bus clock which is at 40 Mhz maximum!
to run at 100Khz that would leave a maximum resolution of 400 counts per PWM period. or a modulus of 400 if edge aligned, or 200 if center-aligned!

I am not aware of any method that would allow you to increase the resolution beyond 400 counts at 100Khz.

Jerry.

-----Original Message-----
From: Bruno Tremblay [mailto:b...@gentec.ca]
Sent: Friday, January 17, 2003 8:36 AM
To: m...@yahoogroups.com
Subject: [motoroladsp] Increase resolution for a high frequency PWM on
DSP56803

Hi,

Is it possible to increase the resolution for the PWM output when using
it at a frequency of about 100kHz? I looked at the chapter 11 of the
user's manual and I didn't found my answer. Can I put an external fast clock
on an input to speedup timer the PWM timer/counter.

Thanks

Bruno

_____________________________________
Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer.  You need to do a "reply all" if you want your answer to be distributed to the entire group.

_____________________________________
About this discussion group:

To Join:  m...@yahoogroups.com

To Post:  m...@yahoogroups.com

To Leave: m...@yahoogroups.com

Archives: http://www.yahoogroups.com/group/motoroladsp

More Groups: http://www.dsprelated.com/groups.php3
 

" TARGET="_blank">http://docs.yahoo.com/info/terms/

________________________________________________________________________
This email has been scanned for all viruses by the MessageLabs SkyScan
service. For more information visit http://www.messagelabs.com
________________________________________________________________________