>I have had this problem before and it is a bug on the DSK. There are
two
>ways around it,
The first is to ground all of the parallel port data pins coming off
the
dsk. The other is to Switch off (up)
Switch #1 on SW1, This disconnects the parallel port from the DSK. I
suggest the second.
Joel
>________________________________________________________________________
>________________________________________________________________________
>
>Message: 2
> Date: Wed, 04 Sep 2002 07:23:31 -0000
> From: "satish_tvs" <>
>Subject: problem with flash programming
>
>hello,
>
>i have one application. i have created .hex file and programmed flash
>using flash burn utility. when i have removed jp2 and reset the dsk,
>application is running fine. but if i remove my parallel port
>connection and reset the dsk once again, the application in the flash
>is not running. When dsk board is connected to parallel port flash
>booting is fine. but if i remove parallel port then flash bootin is
>not taking place. If any body has experienced same problem, please
>help me.
>
>thank u,
>
>satish
|