RE: [motoroladsp] JTAG_OVER_FLASH (Delta 0.6) option -info
I believe you are correct, however, if you set that bit, it is my understanding that you will run into problems if any of your interrupt routines or functions called from interrupt routines need to access data or code from that flash unit. Those routines will fail if the interrupt occurs while you are accessing the information block!!! Thus it would seem to be imperative to only read the information block at initialization time, and only while interrupts are disabled. If that is your intended use, then you basically set that bit, and read the flash memory using the first address block of the flash unit. I am not sure which 4 bytes you would get from accessing the program memory information block at address 0x0000, since that is mapped into Boot flash!!! I suspect, to get the correct values, you would need to start your program information block values at address 4, and read them back starting at address 4. Jerry. -----Original Message-----
Dear friends, The Dos utility "jtag_over_flash.exe" to download
Software to the DSP Family
Does somebody has used this option already, if yes, may I have
a copy of
thanks and regards
__________________________________
_____________________________________
_____________________________________
To Join: m...@yahoogroups.com To Post: m...@yahoogroups.com To Leave: m...@yahoogroups.com Archives: http://www.yahoogroups.com/group/motoroladsp More Groups: http://www.dsprelated.com/groups.php3
" TARGET="_blank">http://docs.yahoo.com/info/terms/ ________________________________________________________________________
________________________________________________________________________ This email has been scanned for all viruses by the MessageLabs SkyScan service. For more information visit http://www.messagelabs.com ________________________________________________________________________ |