Mabuhay! Roy, Selftest polls HINT to check dsp-to-pc interrupt. The poll duration could be too short in a Pentium II or III. Try increasing the duration by modifying HINT(duration) in line 190 of selftest.cpp (\dskplus\source) and recompile. Hope this helps. Stephen ----- Original Message ----- From: "Roy Closa" <> To: <> Sent: Wednesday, November 06, 2002 10:26 AM Subject: [c54x] Clock Speed Problem? > Hello everybody!! > > I have tried to initialize my TMS320C542 in a > 100-Mhz Pentium I and selftest.exe is successful. > However, I tried to initialize other TMS320C542's > (3 kits in all) in a Pentium II and Pentium III PC's > the selftest.exe (under c:\dskplus) responded with: > Attempting 8-bit Data I/O . . . . > 8-bit Mode is Functional > > No response from HINT interrupt signal. > > * * * * TEST FAILED * * * * > I have tried the change the I/O configurations among > Normal, EPP, ECP and EPP+ECP but to no avail. > > Is it really so that TMS320C5xx and TMS320C54xx DSP > kits can run only on Pentium I platform? or is there > a way to overcome this problem. > > I hope somebody in the group can answer this problem. > Thank you!! > > > _____________________________________ > Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > > To Post: Send an email to > > To Leave: Send an email to > > Archives: http://www.yahoogroups.com/group/c54x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ > > |