Reply by Kenneth Porter September 30, 20022002-09-30
On Mon, 2002-09-30 at 00:42, amol gavande wrote:
> hi,
> i am writing a simple program in which i am
> initializing UART registers and one isr routine in
> which i am doing loopback. but the problem is that the
> processor is not generating the IRQ2 interrupt which
> is the UART interrupt. so it is not going in the isr
> routine. i am writing this program in C.
> plz solve my problem.

Put an oscope on the IRQ2 signal and see if the UART is generating it.
That should tell you if the problem is in the UART or in the SHARC.

I've never used one of these kits so I can't help beyond that.

[Please direct replies to the list.]


Reply by amol gavande September 30, 20022002-09-30
hi,
i am writing a simple program in which i am
initializing UART registers and one isr routine in
which i am doing loopback. but the problem is that the
processor is not generating the IRQ2 interrupt which
is the UART interrupt. so it is not going in the isr
routine. i am writing this program in C.
plz solve my problem.