|
Hello all, Is this a known issue? I have looked for info on it but with no success. Using CCS 2.10 targetting a '5416. I find that the graphical configuration of McBSP pins used as GPIO is not very sticky. Making changes in the configuration of other elements in the McBSP configure dialog will cause the GPIO direction bits to be overwritten (outputs turned into inputs. The GPIO page of the McBSP configuration dialog still shows Output but the bits (as seen in the Advanced tab) of the PCR are set for inputs. Is this a know issue? Is there a solution (apart from the obvious of setting the bits to inputs and back to outputs anytime any changes are done to the McBSP config)? Ian Wilson |