HI
What brand of emulator do u use??
Best regards
Peter
On 30/04/2009, l...@cidesi.mx wrote:
> Hi
>
> Has anyone ever used the TMS320C6745?
> I cant configure it? I open the Code Composer Studio Setup and create a
> board, i choose the SD510USB Emulator (Im working with the XDS510 USB PLUS
> Emulator)and i also choose the processor type c6745 which includes an
> ICEPICK_C and the TMS320C674XP.
> When the setup is finished i save and quit and the Code Composer Studio
> starts.
>
> The problem comes when i try to connect the target, i have the following
> error:
>
> Error connecting to the target:
> Error 0x80000240/-1146
> Fatal Error during: Initialization, OCS,
> Invalid data was scanned by the emulation controller.
> Verify the board setup to make sure the scan chain is properly
> defined.
> If the setup is correct, then RESET EMULATOR. This will disconnect each
> target from the emulator. The targets should then be power cycled
> or hard reset followed by an emureset and reconnect to each target.
> I/O Port = 510
>
> Board Name: Target_c6745
> Cpu Name: TMS320C674XP_0
>
> Abort: Close Code Composer Studio.
> Retry: Try to connect to the target again.
> Cancel: Remain disconnected from the target
> Diagnostic: Run diagnostic utility.
>
> I dont know if the problem is the configuration or the Hardware with the
> JTAG, has anybody a diagramm of how to connect the TMS320C6745 with the
> JTAG?
>
> Thanks in advance.
>
>
> _____________________________________
>
_____________________________________