you should create a secondaty linker command file (let say test.cmd)
The first thing to do in this command file is including the command file
generate
by DSP/BIOS.
using
-l file.cmd
followed by your user specified memory sections.
You must then remove the DSP/BIOS generated command file from the Code
Composer
project and
use test.cmd instead.
This is the way of doing it according to some TI example and it works for me.
cheers,
Paul
------
Paul Kamphuis
DSP engineer
www.jive.nl
Joint Institute for VLBI in Europe Phone : +31-521-596535
Radiosterrenwacht Dwingeloo or : +31-521-596500
Postbus 2 Fax :
+31-521-597332
7990 AA DWINGELOO, the Netherlands
PLEASE NOTE: In the near future "" may be the
only proper address, old addresses in your aliases could fail.
>>> 10/03/00 07:15AM >>> Hi all,
If I create a DSP/BIOS configuration file, the code composer also
generates a linker command file. I have some user specific memory
section which I add manually into the linker command file. If I change
the DSP/BIOS configuration file, the linker command file will also be
changed and my user specific memory section are overwritten.
Where can I define this user specific memory section in the way that
they will not be overwritten each time I change my DSP/BIOS
configuration file?
Thanks in advance.
Thomas
--
//\\\\
| ~ ~ |
( O O )
___________________________________oOOo______( )_____oOOo_______
you must create you own linker file and then include the CCS generated one on
the first line in you costum one like the following:
-l applcfg.cmd /*specify multiple linker cmd files*/
Best regards
Lars Skade
This email is intended for the above named only. It may contain private and
confidential information or material that is privileged. If it has come to
you
in error you must take no action based upon it, nor must you copy or show it
to
anyone. Please return the message immediately to .
-----Original Message-----
From: Thomas Schwere [SMTP:]
Sent: Tuesday, October 03, 2000 8:15 AM
To: ;
Subject: [c6x] DSP/BIOS II
Hi all,
If I create a DSP/BIOS configuration file, the code composer also
generates a linker command file. I have some user specific memory
section which I add manually into the linker command file. If I change
the DSP/BIOS configuration file, the linker command file will also be
changed and my user specific memory section are overwritten.
Where can I define this user specific memory section in the way that
they will not be overwritten each time I change my DSP/BIOS
configuration file?
Thanks in advance.
Thomas
--
//\\\\
| ~ ~ |
( O O )
___________________________________oOOo______( )_____oOOo_______
If I create a DSP/BIOS configuration file, the code composer also
generates a linker command file. I have some user specific memory
section which I add manually into the linker command file. If I change
the DSP/BIOS configuration file, the linker command file will also be
changed and my user specific memory section are overwritten.
Where can I define this user specific memory section in the way that
they will not be overwritten each time I change my DSP/BIOS
configuration file?
Thanks in advance.
Thomas
--
//\\\\
| ~ ~ |
( O O )
___________________________________oOOo______( )_____oOOo_______