> May i know what is meant by JTAG emulation via
PCI?, how to achieve it?,
1) The JTAG test bus controller is co-located on the board with the DSP, and
accessible over the PCI bus from a host software program (think EVM board and
2) A separate PCI card is used that has JTAG test bus circuitry, and the
1149.1 14-pin ribbon cable is run to the target DSP board. Innovative
CodeHammer is such a high-performance solution.
DSP sw/hw engineer
Reply by pete●December 17, 20022002-12-17
The XDS510 is an ISA bus board.
The newer XDS560 is an emulation card that fits to the PCI bus.
Using the PCI bus gives better performance, but the XDS560 also has
extra features that you might or might not find useful.
> -----Original Message-----
> From: raja nayaka [mailto:]
> Sent: Tuesday, December 17, 2002 7:38 AM
> Subject: [c6x] JTAG Emulation via PCI
> hi friends
> May i know what is meant by JTAG emulation via PCI?, how to
> achieve it?,
> what interface i need, to make communication between JTAG
> and CCS , other than using XDAS510....
> please give me your suggetion
> thanking you
> Note: If you do a simple "reply" with your email client, only
> the author of this message will receive your answer. You
> need to do a "reply all" if you want your answer to be
> distributed to the entire group.
> About this discussion group:
> To Join: Send an email to
> To Post: Send an email to
> To Leave: Send an email to
> Archives: http://www.yahoogroups.com/group/c6x
> Other Groups: http://www.dsprelated.com
Reply by raja nayaka●December 17, 20022002-12-17
May i know what is meant by JTAG emulation via PCI?, how to achieve it?,
what interface i need, to make communication between JTAG and CCS , other
than using XDAS510....