Please send your problem to the address
below:
-----------------------------------
John L. WintersSr. Application Engineer DSP
Operation 8/16 Bit Products Division Transportation & Standard Products
Group Motorola Inc. 2100 E. Elliot Road, Tempe, Arizona 85284
----------------------------------- * For faster turnaround in answering support questions please
access * * Motorola’s
Customer Support web site at * *
http://www.motorola.com/semiconductors/support * * * *
Or send email to: D...@motorola.com * -----------------------------------
Dear Jac,
I had posted my GPIO problem, but it seems that the moderator did not allow it
to go on the group messages..What should I do?
Hi..
I m new to dsp56f807 and working on ADC programming. I m using both ADCA and B with a sampling rate 3.2K. .. Also, I m not able to use
GPIOE2 and E3 which are muxed with A6 and 7 as GPIO's My DSP 56 F807 EVM pins do not show any change of
states. But if i read the GPIO using GPIO_READ i m able to get the values.Is
there a problem in the EVM or in software?
thanks in advance
Seto
Yahoo! Plus - For a better Internet
experience_____________________________________ Note: If you
do a simple "reply" with your email client, only the author of this message will
receive your answer. You need to do a "reply all" if you want your answer
to be distributed to the entire group.
_____________________________________ About this discussion group:
To Join: m...@yahoogroups.com
To Post:
m...@yahoogroups.com
To Leave: m...@yahoogroups.com
Archives: http://www.yahoogroups.com/group/motoroladsp
More Groups:
http://www.dsprelated.com/groups.php3
">Yahoo! Terms
of Service.
|