Jeeva,
On Sat, Jul 31, 2010 at 2:23 AM, wrote:
> Hi All,
>
> Our board(Product) has TCI6488 processor. We have a blackhawk JTAG
> emulator. we have installed the CCS V3.3 with SR12 patch and installed the
> JTAG driver. While we are trying to open the emulator debugger and tried to
> connect to the target it shows the below error message.
>
> Error connecting to the target:
> Error 0x80002240/-183
> Fatal Error during: Initialization, OCS, Control,
> This error was generated by TI's USCIF driver.
>
> SC_ERR_CTL_CBL_BREAK_FAR <-183>
> The controller has detected a cable break far-from itself.
> The user must connect the cable/pod to the target.
>
This error means that the target board is not detected.
All that is needed is for the JTAG connector to have ground and presence
detect voltage. [assuming that the emulator address is correct]
mikedunn
>
> Board Name: Blackhawk USB560bp - TCI6488 Emulator
> Cpu Name: ICEPICK_C_0
>
> Abort: Close Code Composer Studio.
> Retry: Try to connect to the target again.
> Cancel: Remain disconnected from the target
> Diagnostic: Run diagnostic utility.
>
> Can any one help or have any suggestion?
>
> Thanks in advance,
>
> -Jeeva
>
>
--
www.dsprelated.com/blogs-1/nf/Mike_Dunn.php