Fixed. Bits 13 and 14 of BSCR, on the 5407, sets a CLK divider to put on the CLKOUT pin. Properly setting both bits to 0 resulted on CLKOUT having the expected frequency. Thanks, Believer --- In , "the_believer_1976" <the_believer_1976@y...> wrote: > Hi everyone, > > I am having a strange behavior when running my board with > boot via parallel bus. > > The programm is completely loaded and running properly, but the > CLKOUT signal is 4 times lower than expected. It was expected > 117.6MHz, but there is 29.4MHz. > > Note 1: I am using the two internal DSP5407 timers, and they are > generating interruptions as if the clock was 117.6MHz! > > Note 2: when debugging with my PC and JTAG interface, CLKOUT runs > at 117.6MHz. So the problem is only when booting from external memory. > > > Any information will be very valuable. > > Thank you very much, > Believer |