The problem was the change of the DSP silicon revision from 1.03 to 1.1 - we
had to change the CCS 2.12 driver
Gabriel Drenger
-----Original Message-----
From: gururajb2 [mailto:]
Sent: Thursday, April 24, 2003 6:21 AM
To:
Subject: [c6x] CCS Bring up through JTAG for C6415
hi all,
I am facing problem in bringing up CCS through JTAG for C6415 .Since
all conections to JTAG header is less than 6 inchs i am not using any
signal buffering.
Pls inform any other precautions are to be taken for JTAG.
Thanks in advance.
--
gururaj
_____________________________________
Note: If you do a simple "reply" with your email client, only the
author of
this message will receive your answer. You need to do a "reply all" if
you
want your answer to be distributed to the entire group.
_____________________________________
About this discussion group:
hi,
I am using customized C6415 board for some product.I am using JTAG
for debugging.We made Following connections for JTAG header and DSP
1.TRST is pulled down and connected to DSP and Header
2.4,8,10,12 pins of JTAG header is conneced to GROUND.
3.12 and 13 pins of Header is puuled up and connected to DSP EMU0 and
EMU1 pins
4.TCK_RET and TCK(9 and 10 pins of Header)shorted and connected DSP
respective pins
5.TDI and TDO (3 aND 7 PINS of Header)pulled up and connected to DSPs
respective pins.
6.TMS (pin no 1 of header) is directly connected to DSP.
But we r not able bring up CCS through JTAG emulator.Pls
inform me if any problem in the above hardware connections and also
send u r comments.
Thanks in advance.
--
gururaj
Reply by gururajb2●April 24, 20032003-04-24
hi all,
I am facing problem in bringing up CCS through JTAG for C6415 .Since
all conections to JTAG header is less than 6 inchs i am not using any
signal buffering.
Pls inform any other precautions are to be taken for JTAG.