About 2 years ago I wrote code using an older version of CCS and was able to
configure interrupts using IRQ_ CSL calls without having to use CCS and
DSP/BIOS.
I have tried to repeat the above using CCS 2.12.14, but find there are
conditions to using IRQ_configArgs() that say a DSP/BIOS .cdb file must be
used.
Is there any documentation on how to use IRQ_ macros to develop an
application
that DOES NOT use DSP/BIOS ? Has anyone done this ?
Thanks,
Andrew E.
_____________________________________
Note: If you do a simple "reply" with your email client, only the
author of this
message will receive your answer. You need to do a "reply all" if you
want your
answer to be distributed to the entire group.
_____________________________________
About this discussion group:
About 2 years ago I wrote code using an older version of CCS and was able to
configure interrupts using IRQ_ CSL calls without having to use CCS and
DSP/BIOS.
I have tried to repeat the above using CCS 2.12.14, but find there are
conditions to using IRQ_configArgs() that say a DSP/BIOS .cdb file must be
used.
Is there any documentation on how to use IRQ_ macros to develop an
application
that DOES NOT use DSP/BIOS ? Has anyone done this ?
Thanks,
Andrew E.
_____________________________________
Note: If you do a simple "reply" with your email client, only the
author of this
message will receive your answer. You need to do a "reply all" if you
want your
answer to be distributed to the entire group.
_____________________________________
About this discussion group: