Anand,
I am sure that was s-l-o-w. You must use a user defined TCLK value
for 1.0x devices. I believe that the value that you enter in is 2x the
desired clock rate. Ti's default configuration used 10 mhz [I cranked
mine to 20 mhz and had no problems].
mikedunn
Anand K <a...@yahoo.com>
wrote:
Thanks for your help. I figured that the required update was:
2.20.18
However, it would be nice if someone could tell me how to
choose the Clock (TCLK) in the "Board Properties" tab of CCS Setup tool. I
chose "User Defined" and left the value at 1, ("Automatic" will not start up CCS) and then the system is really slow. For e.g. file write onto host disk from the IEK is happening at like 2 KB / sec; Im sure the
XDS560 can run faster than that :) !
Thanks in advance for any
help.
Regards Anand
--- In c...@yahoogroups.com,
KAnand wrote: > Hello all: > > I am having trouble with
obtaining the correct > configuration for this > setup: > > 1. ATEME's IEKC64 with C6416 Dsp, Silicon Rev 1.03 > 2. Code Composer Studio 2.2 > 3. XDS560 Emulator > > I did not
have to use the emulator's drivers since > there is a driver that
comes with CCS 2.2. My problem > is, after a complete install and
restart, I do not see > my configuration in the "Available
configuration" tab > of CCS Setup and there dont seem to be any .dvr
files > that I can import to get this one on. The right >
configuration I am supposed to use for my setup
is:_____________________________________ Note: If you do a simple "reply"
with your email client, only the author of this message will receive your
answer. You need to do a "reply all" if you want your answer to be distributed
to the entire group.
_____________________________________ About
this discussion group:
To Join: Send an email to
c...@yahoogroups.com
To Post: Send an email to
c...@yahoogroups.com
To Leave: Send an email to
c...@yahoogroups.com
Archives:
http://www.yahoogroups.com/group/c6x
Other Groups:
http://www.dsprelated.com
|