Reply by dileepan_c ●February 4, 20052005-02-04

hi,

The processor cares for the ready signal only when atleast two wait
states are programmed.with swwr=0 you may not be able to do this.

regards,
Dileepan.
--- In , "gil_de_boulages" <gil_de_boulages@y...>
wrote:
>
>
> Hi everybody,
>
> i'm using 54CST on Sprectrum board.
>
> My application run with DSP/BIOS at 118Mhz.
>
> I've include Flash utilities for save audio message in flash
memorie,
> but even with 14 wait cycles i can't write in flash.
>
> Manualy, with my XDS510 PPPlus i can change value and so hardware
is
> ok.
>
> I would like to know if with SWWSR at 000, the dsp wait the READY
> signal or is there other this to do ?
>
> Any information will help me, so thanks before.
>
> Gilles


Reply by gil_de_boulages ●February 4, 20052005-02-04


Hi everybody,

i'm using 54CST on Sprectrum board.

My application run with DSP/BIOS at 118Mhz.

I've include Flash utilities for save audio message in flash memorie,
but even with 14 wait cycles i can't write in flash.

Manualy, with my XDS510 PPPlus i can change value and so hardware is
ok.

I would like to know if with SWWSR at 000, the dsp wait the READY
signal or is there other this to do ?

Any information will help me, so thanks before.

Gilles