Something is incorrectly configured in cc_setup. The error message
that you are seeing indicates that you have most likely selected a TI driver
instead of an SD driver.
miikedunn
aporaria <a...@yahoo.ca>
wrote:
I have designed a board around TI's C6711. I am
trying to perform emulation under CCS 2.20 using the spectrum's
XDS510PP emulation POD. The "SDConfig" finds and passes the Jtag chain with
results like:
** Emulator Test ** $$ EmuProductName=XDS510PP $$ EmuPortAddr=0x378 $$ EmuPortMode=SPP8 $$ ProductId $$
ProductVersion ** Emulator Scan Test -- Found JTAG IR length of 46 -- Found 1 JTAG device(s) in the scan chain The CCS however, fails every
time usually with the message:
..Can't Initialize Target CPU ..ERROR 0x80000200/-118 ..Fatal Error during: OCS, ..This error was
generated by TI's USCIF driver. ..SC_ERR_CTL_PORT <118> as
if CCS can not find the POD in that particular location (0x378) or access
parallel port at 0x378.
and sometimes, if I change the driver I get a
memory access error under
win2K, and CCS crashes.
I have searched the archives and know there
have been problems reported similar to mine and tried a some of
solutions offered, but nothing seems to make a difference.
Could it
be an OS + driver issue? Any ideas? _____________________________________ Note: If you do a simple "reply"
with your email client, only the author of this message will receive your
answer. You need to do a "reply all" if you want your answer to be distributed
to the entire group.
_____________________________________ About
this discussion group:
To Join: Send an email to
c...@yahoogroups.com
To Post: Send an email to
c...@yahoogroups.com
To Leave: Send an email to
c...@yahoogroups.com
Archives:
http://www.yahoogroups.com/group/c6x
Other Groups:
http://www.dsprelated.com
|