No I'm not using it.
What I'm using is the MATLAB Link for Code Composer Studio version
number 1.
http://www.mathworks.com/products/ccslink/
On my first post I only specified (not complete) my system setup.
I would like to read and write variables (MATLAB <-> CCS), at the
moment only possible with matlab's read() and write(). I would like to
use matlab's createobj() unfortunatelly yet with out success.
Regards
PS: The code composer version is 2.12.07
Reply by Brad Griffis●December 1, 20042004-12-01
Are you using Embedded Target? From the Mathworks website I don't see any
products called Embedded Toolbox:
http://www.mathworks.com/products/product_listing/
The two versions of Embedded Target for TI DSPs are for C2000 and C6000
DSPs. There is no support for C5000 DSPs.
Brad
<lathe_biosas@hotmail.com> wrote in message
news:f3fb6877.0412011638.77a96864@posting.google.com...
> Hi
>
> Im trying to get the variable x from Code Composer via Matlab the
> following way
>
> variable=createobj(cc_target,'x')
>
>
> but there is and error message from matlab:
>
> ??? Processor not supported
>
>
> The variable x on Code Composer has been int,double,float
> x has been also an structure and an array but createobj still says:
>
> ???Processor not supported
>
> I'm using the TMS320VC5510 and the versi�n 1 of the Embedded Toolbox TI
>
> How is it possible to solve the problem?
> Best Regards and thank you very much
Reply by Keith Thompson●December 1, 20042004-12-01
lathe_biosas@hotmail.com writes:
> Im trying to get the variable x from Code Composer via Matlab the
> following way
>
> variable=createobj(cc_target,'x')
>
>
> but there is and error message from matlab:
>
> ??? Processor not supported
[...]
This is not a C question. Followups trimmed.
--
Keith Thompson (The_Other_Keith) kst-u@mib.org <http://www.ghoti.net/~kst>
San Diego Supercomputer Center <*> <http://users.sdsc.edu/~kst>
We must do something. This is something. Therefore, we must do this.
Reply by ●December 1, 20042004-12-01
Hi
Im trying to get the variable x from Code Composer via Matlab the following way
variable=createobj(cc_target,'x')
but there is and error message from matlab:
??? Processor not supported
The variable x on Code Composer has been int,double,float
x has been also an structure and an array but createobj still says:
???Processor not supported
I'm using the TMS320VC5510 and the versi�n 1 of the Embedded Toolbox TI
How is it possible to solve the problem?
Best Regards and thank you very much