Hey
Just working with the Motorola DSP56858 and Boot mode 2. Trying to boot off Flash memory at the moment, have written the program to 0x40000 and once I reset the board it does load up and blink the LED at me to tell me its all fine. Which is great, but, I’ve also got some data which I’ve written to a few spots on the flash. Once at 0xA000 and again at 0x42000 and I’m trying to read it off the flash, but to no avail. Have tried reading at the locations 0xA000, 0x4A000, 0x2000, 0x42000. Does anyone know where flash data is remapped to? Or isn’t it remapped at all, and only the program can run from the 0x40000 start point.
Also in the user manual it states “In operating mode 2, chip select 0 is initially set to $040000” and this contradicts how it has work.. Since I can write my code to $040000 on the flash and that’s where the program runs when I reset into operating mode 2… Can someone explain?
Rajesh Singh r...@shockdesign.com.au www.shockdesign.com.au |