|
Hello, Matlab could be great for system simulation and algorithm functionality. You can even use "hardware in the loop" validation of your system (*). But when it comes to implementing in a specific hardware platform, you'd rather implement what your Matlab code does in the programming language of the hardware platform: ASM/C/C++/Verilog/VHDL (the latter even suposing you are targeting your system to an FPGA). I'd use Matlab/Simulink to understand how should the system be, what should each module do. Then, implement the modules. JaaC -- (*) There exists DSPDeveloper from SDL. Check this out: www.sdltd.com. It allows you to run your Simulink code (blocks) into real DSP hardware: SHARC, TigerSHARC, Blackfin. --- Mike Rosing <> wrote: > On Wed, 11 Aug 2004, Jaime Andres Aranguren Cardona > wrote: > > > Hi, > > > > I think it would use libraries specific to Matlab > > and/or Realtime Workshop, I am not sure. > > > > I think it's worth checking with the generated > code to > > see what calls does it make. > > I agree, if you are using floats it may go thru a > lot of machinations you > don't really need. Worst case you can just feed the > C output from matlab > to the VDSP compiler by hand. I'd personally never > do that though - way > too many things can go wrong and you won't know > where they are happening. > > Patience, persistence, truth, > Dr. mike ===== Jaime Andr Aranguren Cardona __________________________________ |