Dear who concern I have tried to load DSP56F801F80 Serial Bootloader from CodeWarior Processor Expert Stationary Example into my developed board with DSP56F801, 80MHz. The result that had no problem for this demo SDK to connect a hardware through PC serial port (That I have used Hyperterminal) . However, the specification to use this Demo Serial Bootloader are that Baud rate must be 115200 bps, Bit rate was 8 and Flow control was Xon/Xoff. Now, my project uses Baud rate about 56700 bps. I have tried to change the config in Processor Expert's SCI bean that intitial was 115200 bps modified to 57600 bps, and then run debug again. Unfortunately, These initial config didn't change. A hardware has still connected in Baud rate 115200 bps, not in 57600 bps. So, I have tried to debug through this example code, but I couldn't find where I can change the config of Baud rate. I'm not sure that the code (This 56F801 serial bootloader) which I have debugged has changed because it behaved same as not debugged yet. At last, I'm still cannot use in 57600 bps Serial Bootloader. Anyone know please help me! Thanks in advance Pitchaya V.