1) Tie /TRST to ground and set EOnCE_EBL bit = 0 will
disable EOnCE.
2) To further reduce the current consumption, disable
PLL and clock the CPU core by prescale clock.
Charlie
--- Hardeep wrote:
> Hi,
>
> I am using the DSP56858. Is there a way to turn off
> the EOnCE module
> once the board has been programmed? The reason I am
> asking this is to
> determine whether and/or how much current is being
> consumed with it
> on. I have created a project in which I put the DSP
> into Wait mode
> (wait for interrupt) with no interrupts enabled
> (other than the core
> interrupts that may occur) so that I can measure the
> current
> consumption while it is in wait mode. However, the
> measured current
> consumption does not fall within what is specified
> on the spec sheet.
> Could the EOnCE be causing this extra current
> consumption as it is the
> only other module actually running in my program?
>
> Thank you.
> Hardeep
>