Hi Slawek, this error message seems familiar to me. I wrote several C-files, which communicated with an external DLL (to access to a PCMCIA card). These error messages occurred due to the access of the external DLL. My solution was to write an 23bit-C-File using my MSVisual C(++) 6.0 compiler, which worked like an nutshell. I defined commands, which only accessed the external DLL. Afterwards I produced an DLL out of these commands. Writing my C-file / mex-File I included only my self-generated DLL. Luckily these error messages didn't occur any longer. I hope, I could help you a little bit. Don't hesitate to contact me for further information. Gerhard Hella KG Hueck & Co. Dep.: FT-LS Gerhard Bierleutgeb Rixbecker Str. 75 D - 59552 Lippstadt / Germany Tel.: + 49 / (0)2941 / 38 - 1042 Fax.: + 49 / (0)2941 / 38 - 1566 "Drabot, Slawek" An: "'" <> <> Kopie: Blindkopie: 25.07.01 18:57 GMT Thema: [matlab] Mex Error on Solaris Hi again, I noticed that the error I was getting was consistent between using both the Gnu Fortran and Sun C compilers and consists of: symbol s_rsue: referenced symbol not found Any help identifying the problem causing this error would be appreciated. Thanks, Slawek Drabot Otis Elevator Company Ph.: 860/676-5202 Fx.: 860/676 5494 em: _____________________________________ Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. _____________________________________ About this discussion group: To Join: To Post: To Leave: Archives: http://www.yahoogroups.com/group/matlab More DSP-Related Groups: http://www.dsprelated.com/groups.php3 ">http://docs.yahoo.com/info/terms/ |