Hi !!!
I needed the following
help.........
I have a DSK C6711 board with
me............
I am trying to port my code on the
DSP..
I am new to using the DSK...
The following are the
problems.....
I have a code which compiles & linkes
without any problem........
i looked at the Map file for making
changes in the Command file......
since my code doesnot fit completely in the
Internal RAM ( 64 KB )
i have put certain sections in the External memory ( starting at 0x80000000
)
the code loads on the DSP without any problems
........ ( some times if i change the location i have a problem )
now when i want to debug i have a problem the
it debugs only till some stage & then i get this dis assembly
window......
I think it is a Memory problem............ kindly sugget....
i think my code is falling in the restricted
areas of the memory...........hence i am not able to run after
loading....
My questions are as
follows.........
1) Is a linker command file a MUST to port
the code on the target coz i have loaded a few Tutorial programs that
run with or
without the command file.........and it
still works
2) where can i get the information on the
linker command files........
Can i run the code completely on the External
RAM ( i think it should be possible kindly clarify......)
or should some part of the code be on the
Internal RAM.....
3) Where can i get the complete Memory map of
C6711 DSK i have looked at GEL_MAPADD( ) of C6211;
in the CCS 2.0.
I am sure ur that ur suggestions will be
of great help.......
bye
nikhil