Hi! Can you be more specific about this?? I can't find any indications about use RTDX without CCS2.0 ? Thanks. --- In c6x@y..., "Clasquin, Ferry" <f-clasquin@t...> wrote: > Hi Steve, > > The below question on RTDX without Code Composer Studio running with a > Visual C++ or Visual Basic > is possible, but only from up Code Composer Studio 2.0 release. The current > version you are using > the RTDX is part the the CCS COM object and with CCS 2.0 this is a seperate > DLL. > > Now is you question how do I get CCS 2.0, if you have registered you DSK via > the Web you should > get the tool at the latest October 2001. If not write a message to > support@t... or for Europe > epic@t... and request a update for the DSK. > > Best regards, > > Ferry Clasquin > -----Original Message----- > From: seechung@y... [mailto:seechung@y...] > Sent: Friday, September 28, 2001 7:14 AM > To: c6x@y... > Subject: [c6x] RTDX and Visual C++ without CCS > Hi all, > > I am using TMS320C6711 DSK with Code Composer v1.23. I wrote a > program using Code Composer to send number stored in an array to > McBSP, using interrupt-driven method (XINT1). That was working fine > as I can see the bit patterns (1s and 0s) of the number sent to McBSP > on an oscillscope. > > However, I would like to do that without using Code Composer at all. > Instead I would like to use Visual C++ and RTDX. (refer to TI's > spra744, spra591) But as far as I know, it requires Code Composer to > enable RTDX: Tool | RTDX | enable RTDX, because Code Composer act as > the COM server for RTDX. > > I can write Visual C++ COM client for RTDX, which requires Code > composer to enable RTDX. > > Just wondering has anyone be able to enable RTDX without Code > composer? Or does anyone know any document available that might help > to solve my problem? Any helps would be greatly appreciated. ;) > > In addition, has anyone be able to load, run and stop the DSK program > without using Code Composer? This is an example dsk6xldr under > \ti\c600\examples\dsk\dsk6xldr which gives some clues. > > Thank you for your kind attention. > > Steve Ma > seechung@y... > > _____________________________________ > Note: If you do a simple "reply" with your email client, only the author of > this message will receive your answer. You need to do a "reply all" if you > want your answer to be distributed to the entire group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to c6x-subscribe@y... > > To Post: Send an email to c6x@y... > > To Leave: Send an email to c6x-unsubscribe@y... > > Archives: http://www.yahoogroups.com/group/c6x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ |