Dave-
> Hi guys, im trying to design a DMT system. Iv built a
workin model in simulink
> and now hav to try implement it on a TIc5416 processor. Iv heard that
instead
> of rewriting C code for the DSP, it is possible to get SIMULINK to generate
C
> code from my simulink model ...
First, for what board? SIMULINK requires a specific hardware target to generate
C
code. Second, it has been my general experience that SIMULINK is not going
to
generate efficient real-time code for fixed-point TI DSPs. The results may
serve as
a guide, but in the end you will need to take full control of the C code (and
possibly optimized asm code) running on the DSP and make sure it matches your
MATLAB
simulation architecture and data flow.
-Jeff