Hi , The best way to understand about the usage of peripheral handling that being configured through DSP/BIOS is that rather than going for any manuals or report u can make use of the examples which are there in the ti folder ,after installing the ccs for 6x. You can find the examples at the given path \ti_2.0\examples. This folder contains examples that are making use of DSP/BIOS to configure the peripherals. You can find the examples for McBSP , timer, DMA ,EMIF etc here. These examples are well commented with good explanations for setting the various bits of control register of a particular hardware. Hope this help's a lot. Regards, Praveen Kumar R.P DSP Design Engg Aureole Tech Pvt Ltd B'lore --- rashmi ranjana <> wrote: > Hello, > > I was going through application reports related to > peripheral handling > (for eg. McBSP, EMIF etc..) on ti web page. > I am looking for a report which uses DSP/BIOS to > configure the > peripheral and it's use in a specific application. > But > i didn't find such > report. > can anybody in this grp help me in this regard??? > > Thanks > > > _____________________________________ > Note: If you do a simple "reply" with your email > client, only the author of this message will receive > your answer. You need to do a "reply all" if you > want your answer to be distributed to the entire > group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > To Post: Send an email to > > To Leave: Send an email to > Archives: http://www.yahoogroups.com/group/c6x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ ________________________________________________________________________ Looking for a job? Visit Yahoo! India Careers Visit http://in.careers.yahoo.com |