Sorry forget to say that "+" means connected together.
Thanks
Jesse
On 5 31 , 5 35 , Jessecw <jessechen...@gmail.com> wrote:
> Hi All,
>
> I am going to connect an audio CODEC with C6713. And the CODEC
> has no DSP mode. So I want to use McBSP as an I2S bus.
>
> Here are parts of my schematic.
>
> DSP C6713: CODEC:
> CLKX1----------+
> +------------MCLK (bit clock signal)
> CLKR1----------+
>
> FSX1-----------+
> +------------LRCK
> FSR1-----------+
>
> Here is an example McBSP setting from TI's TMS320C6000 McBSP: I2S
> Interface.
> FSX is output pin
> FSR is output pin
> CLKX is output pin
> CLKR is output pin
>
> My question is: If all pins are set as output pin, will CLKR1 or
> FSR1 work properly? or Are there any problems with my schematic?
>
> Thanks in advance.
>
> Jesse
Reply by Jessecw●May 31, 20072007-05-31
Hi All,
I am going to connect an audio CODEC with C6713. And the CODEC
has no DSP mode. So I want to use McBSP as an I2S bus.
Here are parts of my schematic.
DSP C6713: CODEC:
CLKX1----------+
+------------MCLK (bit clock signal)
CLKR1----------+
FSX1-----------+
+------------LRCK
FSR1-----------+
Here is an example McBSP setting from TI's TMS320C6000 McBSP: I2S
Interface.
FSX is output pin
FSR is output pin
CLKX is output pin
CLKR is output pin
My question is: If all pins are set as output pin, will CLKR1 or
FSR1 work properly? or Are there any problems with my schematic?
Thanks in advance.
Jesse