Hi guys
Can anyone suggest a way to have the TS101 run a script without needing the
VisualDSP++ program. I plan to use the Visual DSP++ to initally load the code
onto the DSP but then want the dsp to run this code without needing to be
attachted to the PC.
Any suggestions? is this doable with our development kits?
regards
kien hou
ADSP TS101- make it run program without visualDSP++
Started by ●July 17, 2006
Reply by ●July 17, 20062006-07-17
On Mon, 17 Jul 2006 h...@hotmail.com wrote:
> Hi guys
>
> Can anyone suggest a way to have the TS101 run a script without needing
>the VisualDSP++ program. I plan to use the Visual DSP++ to initally load
>the code onto the DSP but then want the dsp to run this code without
>needing to be attachted to the PC.
>
> Any suggestions? is this doable with our development kits?
Do you have flash on your TS101 board? Just build a bootable image of
your program into the flash. Look for "boot loader" in your
documentation.
Patience, persistence, truth,
Dr. mike
> Hi guys
>
> Can anyone suggest a way to have the TS101 run a script without needing
>the VisualDSP++ program. I plan to use the Visual DSP++ to initally load
>the code onto the DSP but then want the dsp to run this code without
>needing to be attachted to the PC.
>
> Any suggestions? is this doable with our development kits?
Do you have flash on your TS101 board? Just build a bootable image of
your program into the flash. Look for "boot loader" in your
documentation.
Patience, persistence, truth,
Dr. mike