Enhance Blackfin 561

Can a Infrad receiver be connected to the blackfin 561 using the
UART port ?? Is it possible ??

So that i can control the blackfin board using a infrad remote
controller. Baiscally, I need more buttons to use then the restrict
4 push buttons.

If possible is there any examples ?

I knw that the UART port is used to connect to the serial port of
the pc.

Hmm.. if the infrad implementation cant work.

Can someone give me some idea or tell me how can I use the UART to
do some meaningful project out of it.

Well currently, i am enhancing my project and wanting to extend the
hardware capability.

Thanks whoever can input me with some lights on. :) Start a New Thread

On Wed, 14 Nov 2007, miracle_sksim wrote:

> Can a Infrad receiver be connected to the blackfin 561 using the
> UART port ?? Is it possible ??
>
> So that i can control the blackfin board using a infrad remote
> controller. Baiscally, I need more buttons to use then the restrict
> 4 push buttons.
>
> If possible is there any examples ?

Check out EE-191 on this page:
http://www.analog.com/processors/sharc/technicalLibrary/applicationNotes/index.html

> I knw that the UART port is used to connect to the serial port of
> the pc.
>
> Hmm.. if the infrad implementation cant work.

Sure it can! Check out this page for people who have already done it:
http://www.blackfin.org/developmentboards.php?id

Patience, persistence, truth,
Dr. mike Start a New Thread