Interfacing the bf537 ez-kit with the fpga ez-extender

Hello,

I need to interface the BF537 ez-kit with the FPGA EZ-Extender board in order to realize a project that will receive send data to each other through PPI.
Does anybody can help me to solve this problem?

Thank you Start a New Thread

Hi,

Few years ago, we would like connect FPGA EZ Extender board to BF561 EZ KIT. We tried to connect about few weeks, but we could not achieved EZ KIT to boot properly. Later on we stop dealing with it, and built our hardware, which has BF561 and Xilinx Spartan 3E-1600 FPGA with PPI interface. We have completed the HW and DMA data transfer.

I don't know if there are problems with BF537 ez kit. I can send you PPI DMA int service routine which receives FPGA's sent data with SYNC.

Regards.

Mehmet Ali Ipin

________________________________
From: mocanelu
To: a...
Sent: Tuesday, December 20, 2011 11:36 AM
Subject: [adsp] Interfacing the bf537 ez-kit with the fpga ez-extender

 
Hello,
I need to interface the BF537 ez-kit with the FPGA EZ-Extender board in order to realize a project that will receive send data to each other through PPI.
Does anybody can help me to solve this problem?

Thank you Start a New Thread