I am using RS232 to down load .out file in my 2801 controller. I downloaded
SDFlash and F2801SerialFlash.out from Spectrum Digital. I configured the
SDopts.cfg as instructed in the Reference guide provided by spectrum digital.
The problem is, I have trouble connecting to the target. The same setup works
when I connect through the PC that has code composer installed. I need the stand
alone SDFlash to work. Any ideas why I have this problem?
Zia
Problem with 2801 download through RS232
Started by ●August 17, 2007
Reply by ●August 18, 20072007-08-18
I had similar problems and it turned out that the default rate of
19.2k baud was too fast and I needed to step it down to 9600.
Also make sure that the address you are using is C1.
~Chris
--- In c..., ziaur.rahman@... wrote:
>
> I am using RS232 to down load .out file in my 2801 controller. I
downloaded SDFlash and F2801SerialFlash.out from Spectrum Digital. I
configured the SDopts.cfg as instructed in the Reference guide
provided by spectrum digital. The problem is, I have trouble
connecting to the target. The same setup works when I connect through
the PC that has code composer installed. I need the stand alone
SDFlash to work. Any ideas why I have this problem?
>
> Zia
>
19.2k baud was too fast and I needed to step it down to 9600.
Also make sure that the address you are using is C1.
~Chris
--- In c..., ziaur.rahman@... wrote:
>
> I am using RS232 to down load .out file in my 2801 controller. I
downloaded SDFlash and F2801SerialFlash.out from Spectrum Digital. I
configured the SDopts.cfg as instructed in the Reference guide
provided by spectrum digital. The problem is, I have trouble
connecting to the target. The same setup works when I connect through
the PC that has code composer installed. I need the stand alone
SDFlash to work. Any ideas why I have this problem?
>
> Zia
>
Reply by ●August 23, 20072007-08-23
Thanks; your advice worked.
I am using RS232 to down load .out file in my 2801 controller. I downloaded SDFlash and F2801SerialFlash.out from Spectrum Digital. I configured the SDopts.cfg as instructed in the Reference guide provided by spectrum digital. The problem is, I have trouble connecting to the target. The same setup works when I connect through the PC that has code composer installed. I need the stand alone SDFlash to work. Any ideas why I have this problem?
>
>Zia
I am using RS232 to down load .out file in my 2801 controller. I downloaded SDFlash and F2801SerialFlash.out from Spectrum Digital. I configured the SDopts.cfg as instructed in the Reference guide provided by spectrum digital. The problem is, I have trouble connecting to the target. The same setup works when I connect through the PC that has code composer installed. I need the stand alone SDFlash to work. Any ideas why I have this problem?
>
>Zia
