Hi,
I am using Simulink Target for TI C2000 to program an F2812 eZdsp
board and a TLV5638 DAC to implement digital controllers. However,
initially I am just trying to sample/convert a signal through the ADC,
SPI, DAC and display it on the scope. I have constructed TIC2000
block diagrams to do this, but I don't know how to incorporate the DAC
initialization & control bits in the C2000 diagram. The demo examples
in Mathwork's TIC2000 don't show how to initialize a DAC.
Any help would be much appreciated. If this is not doable, any
suggestion of an alternative approach; e.g using hardware, a different
DAC or software is most welcome.
Best regards,
Kas
OMAP35x EVM jump-starts low-power apps
The modular and extensible OMAP35x Evaluation Module (EVM) enables developers to
start building applications based on the OMAP35x architecture:
http://www.DSPRelated.com/omap35x