PWM
Started by ●February 5, 2009
Hi, can you help me. I use bit FCMP1OE to put PWM1 in high-impedance state. When
in high-impedance state I get high level on output, probably because internal
pull-up on this pin. How can I change this output on low level when pin is
high-impedance state?
Reply by ●February 6, 20092009-02-06
Hi There,
On wich pin in the PWM output connected?
MvdH
Hi, can you help me. I use bit FCMP1OE to put PWM1 in high-impedance state. When in high-impedance state I get high level on output, probably because internal pull-up on this pin. How can I change this output on low level when pin is high-impedance state?
>
>
_____________________________________
On wich pin in the PWM output connected?
MvdH
Hi, can you help me. I use bit FCMP1OE to put PWM1 in high-impedance state. When in high-impedance state I get high level on output, probably because internal pull-up on this pin. How can I change this output on low level when pin is high-impedance state?
>
>
_____________________________________
