Hi, Could anyone please tell me how to find a loopback code for C31 to input from codec and output it again. I will appreciate if you could send me the code. Thanks a lot. |
|
need a simple loopback fpr C31
Started by ●October 15, 2003
Reply by ●October 16, 20032003-10-16
There is a file dealing with loopback in the docs accompanying the C3x starter kit. You can get them through ftp from ti's site. What kind of development tools are you using? Regards, alex ----- Original Message ----- From: m bastan <> To: <> Sent: Wednesday, October 15, 2003 8:46 PM Subject: [c3x] need a simple loopback fpr C31 > > Hi, Could anyone please tell me how to find a loopback code for C31 > to input from codec and output it again. I will appreciate if you > could send me the code. > > Thanks a lot. > > _____________________________________ > Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > > To Post: Send an email to > > To Leave: Send an email to > > Archives: http://groups.yahoo.com/group/c3x > > More Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ |
Reply by ●October 16, 20032003-10-16
Hi There are both LOOPAIC.ASM and LOOP_C.C loopback examples for the C31 DSK. In the new DSK toolset you will find these in the DSK3APPS and C_APPS directories respectively. If you dont have the compiler, it comes with the new VC33 DSK, or you can get a copy by downloading the new tools. You can get a copy of the newest DSK tools from the Spectrum Digital website. Look in "Drivers and Config Utilities", then "University DSK's". As for which examples are C31 or VC33 specific, this has not been sorted out just yet so you will need to read into them a bit. Hope this helps, Keith Larson Note: A new release that will post soon, so you may want to keep an eye out for that. ----------------------------- At 08:12 AM 10/16/03 +0100, you wrote: There is a file dealing with loopback in the docs accompanying the C3x starter kit. You can get them through ftp from ti's site. What kind of development tools are you using? Regards, alex >----- Original Message ----- From: m bastan <> To: <> Sent: Wednesday, October 15, 2003 8:46 PM Subject: [c3x] need a simple loopback fpr C31 Hi, Could anyone please tell me how to find a loopback code for C31 to input from codec and output it again. I will appreciate if you could send me the code. Thanks a lot. +-----------+ |Keith Larson | |Member Group Technical Staff | |Texas Instruments Incorporated | | | | 281-274-3288 | | | | www.micro.ti.com/~klarson | |-----------+ | TMS320C3x/C4x/VC33 Applications | | | | TMS320VC33 | | The lowest cost and lowest power 500 w/Mflop | | floating point DSP on the planet! | +-----------+ |