The computer doesn't recognize the card C5402. When i reset the port 0x378, the software said it can't detect the target power. What can I do to resolve this problem? |
|
Port problem
Started by ●November 5, 2002
Reply by ●November 5, 20022002-11-05
--- In c54x@y..., "samygueye" <samygueye@y...> wrote: > The computer doesn't recognize the card C5402. When i reset the port > 0x378, the software said it can't detect the target power. > What can I do to resolve this problem? Have you checked wether the LPT port is configured as ECP or EPP? This must be done in the computers BIOS, so Windows will reconfigure the port appropriately. Then check it on Control Panel->System->Device Manager->Ports, there must be "Printer port ECP (LPT1)" or something similar. |
Reply by ●November 5, 20022002-11-05
Go into CCS setup and select the edit menu then properties. In the board properties tab, make sure that the i/o port is set to 0x378 Les > The computer doesn't recognize the card C5402. When i reset the port > 0x378, the software said it can't detect the target power. > What can I do to resolve this problem? > > > _____________________________________ > Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > > To Post: Send an email to > > To Leave: Send an email to > > Archives: http://www.yahoogroups.com/group/c54x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ |
Reply by ●November 5, 20022002-11-05
--- In c54x@y..., "samygueye" <samygueye@y...> wrote: > The computer doesn't recognize the card C5402. When i reset the port > 0x378, the software said it can't detect the target power. > What can I do to resolve this problem? A little trick I have to do everytime I change my DSK board: turn- off/on the power from the DSK, then CCS recognizes the board. Otherwise, theres no way the software recognizes it. |
Reply by ●November 5, 20022002-11-05
hi samygueye we bought 2 dsk boards, 1 of them is OK but the other board encounter the same problem like what you mentioned. We tested the faulty board with the pc (which we previously connect with the OK board), but it still couldn't iniatilize the the target. we sent the faulty board for repair. -.......li- --- samygueye <> wrote: > The computer doesn't recognize the card C5402. When > i reset the port > 0x378, the software said it can't detect the target > power. > What can I do to resolve this problem? > > > _____________________________________ > Note: If you do a simple "reply" with your email > client, only the author of this message will receive > your answer. You need to do a "reply all" if you > want your answer to be distributed to the entire > group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > To Post: Send an email to > > To Leave: Send an email to > Archives: http://www.yahoogroups.com/group/c54x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ __________________________________________________ |