|
Hi All ! I connected the McBSP 2 to PCM3002 codec (via CPLD). I also configured the codec by its control registers (via CPLD). I also configured the McBSP2 configurations. I set the IMR to 0x40. INTM=0; I"m recording from microphone and I can see that there is a data changing on DRR12 register but no interrupt recieved. What could be the problem ? Please Help ! Thanks a Lot. |
|
|
McBSP2 Recieve Interrupt (DSK 5416)
Started by ●July 14, 2003
Reply by ●July 15, 20032003-07-15
|
Hi ! did u config the INTSEL register correctly to work with McBSP ? > -----Original Message----- > From: Yuri_Feigin [mailto:] > Sent: Monday, July 14, 2003 6:52 PM > To: > Subject: [c54x] McBSP2 Recieve Interrupt (DSK 5416) > Hi All ! > > I connected the McBSP 2 to PCM3002 codec (via CPLD). > > I also configured the codec by its control registers (via CPLD). > > I also configured the McBSP2 configurations. > > I set the IMR to 0x40. INTM=0; > > I"m recording from microphone and I can see that there is a > data changing on DRR12 register > but no interrupt recieved. > What could be the problem ? > > Please Help ! > > Thanks a Lot. > > _____________________________________ > Note: If you do a simple "reply" with your email client, only > the author of this message will receive your answer. You > need to do a "reply all" if you want your answer to be > distributed to the entire group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > > To Post: Send an email to > > To Leave: Send an email to > > Archives: http://www.yahoogroups.com/group/c54x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ |
