I m currently trying to execute the program called
codec.pjt the following errors seems not to allow me
to run the program appropriatly. If there is any body
who can help plz, plz do reply to me.The errors are
attacted in the above attachment.
Please check the PMST register value when you want to load program. The
error on Problem2.jpg is that the loader application can't load the out
file into 0x7600 address. This address is mapped on 5416 external memory and you
can't run code o it. For do that you should first set your OVLY bit to
1 to map DARAM0to3 into your program memory for using code execution. These
setting can be done by a gel file before loading out file on to your
target.
I m currently trying to execute the program called codec.pjt the following errors seems not to allow me to run the program
appropriatly. If there is any body who can help plz, plz do reply to me.The
errors are attacted in the above attachment.
_____________________________________ Note: If you do a simple "reply"
with your email client, only the author of this message will receive your
answer. You need to do a "reply all" if you want your answer to be distributed
to the entire group.
_____________________________________ About
this discussion group:
<*> To
visit your group on the web, go to: http://groups.yahoo.com/group/c54x/
<*> To unsubscribe from this group, send an email to: c...@yahoogroups.com
<* > ATTACHMENT part 2 image/pjpeg
name=Problems.JPG> ATTACHMENT part 3 image/pjpeg name=Problems2.JPG
Reply by Ganesh Vijayan●May 13, 20042004-05-13
Hi,
Your problem is fairly simple. check the
power supplies of your JTAG (Parallel port) and your board. Most probably
itsn't able to connect to the processor through the JTAG. From your image,
it is evident that you are using parallel port JTAG. So check its
power.
Hope this helps.
Ganesh
----- Original Message -----
From: Saranjeet Singh
To: c...@yahoogroups.com
Sent: Wednesday, May 12, 2004 1:54 PM
Subject: [c54x] codec
I m currently trying to execute the program called codec.pjt the following errors seems not to allow me to run the program
appropriatly. If there is any body who can help plz, plz do reply to me.The
errors are attacted in the above attachment.
_____________________________________ Note: If you do a simple "reply"
with your email client, only the author of this message will receive your
answer. You need to do a "reply all" if you want your answer to be
distributed to the entire group.
_____________________________________ About this discussion group: