Reg XDS510PP - Plus

Hi,

I have a PC that does not have an on-board parallel port.
I have installed a PCI parallel port card.
I am trying to detect JTAG on one of my module using SDConfig.
Windows XP can recognise the parallel ports on my PC,
but SDConfig cannot. I

Is there something I need to change in the sdopts.cfg or some other file
that will help it recognise the LPT ports

Note : The other software can find the LPT ports.

Thanks,
Regards,
Aditi.
Reply

Forward

_____________________________________ Start a New Thread

Hello Aditi,

On 11/3/2010 4:28 PM, Aditi Akula wrote:
> Hi,
>
> I have a PC that does not have an on-board parallel port.
> I have installed a PCI parallel port card.
> I am trying to detect JTAG on one of my module using SDConfig.
> Windows XP can recognise the parallel ports on my PC,
> but SDConfig cannot. I
>

I do not know the answer for sure.
SDconfig was written for a parallel port. For it to function correctly,
I would expect that the PCI parallel port should respond to a base
address of 0x378 or 0x278. Verify that the address in the device manager
matches the SD address that you are using.

mikedunn
> Is there something I need to change in the sdopts.cfg or some other file
> that will help it recognise the LPT ports
>
> Note : The other software can find the LPT ports.
>
> Thanks,
> Regards,
> Aditi.
> Reply
>
> Forward Start a New Thread