|
Following was the problem noticed with the DSK: C6711 DSK - After connecting it with DB15 connector when i try to run code composer in DSK mode, it does not pop up and report the error as 'can't initialize the target'. But if i plug in the emulator cable on the Jtag of dsk board and run the code composer in emulator mode, it runs normally! and then without giving any reset if i plug out the emulator cable and run the code composer in DSK mode it runs normally! But it again gives error if the board is being reset. |
Jeff Brower I need help
Started by ●February 18, 2003
