Hi all,
Im trying load a COFF file (.out) since PC using hpi, but an error
in Code Composer Studio is showed.
The error is "JTAG Communication error".
To load the COFF file Im using 'dsk6xldr' application provided by
dsk 2.0 in 'C:\ti\examples\dsk6711\board_util\dsk6xldr' folder.
The contains of the configuration file (.cfg) Im using is:
;CFG-2.0
;
[POD_DRVR] 'dsk6x11pp.dll'
[POD_MODE] 1
[POD_PORT] 0x378
;[POD_LOG_MAIN] 'pod_main.log'
;[POD_LOG_FUNCTION] 'pod_func.log'
;[POD_LOG_ADAPTER] 'pod_adapt.log'
;
;SCAN PATH
"cpu_a" TI320C6711
Which is the error?
Any help will be appreciated.
Thanks in advance.
Reply by Mike Dunn●May 8, 20042004-05-08
jc [?]
Try it with CCS closed. You do not need CCS for HPI and HPI does not
use JTAG.
I am not sure what you are doing in CCS, but if it is open CCS uses the
parallel port to communicate with the JTAG controller on the DSK while your
program is using the parallel port to communicate with the HPI port on the
DSP. It sounds like at least one of them is getting 'confused'.
mikedunn
jcmarrupe <j...@yahoo.es>
wrote:
Hi all, Im trying load a COFF file (.out) since
PC using hpi, but an error in Code Composer Studio is showed. The
error is "JTAG Communication error".
To load the COFF file Im using
'dsk6xldr' application provided by dsk 2.0 in
'C:\ti\examples\dsk6711\board_util\dsk6xldr' folder.
The contains of
the configuration file (.cfg) Im using is: ;CFG-2.0 ; [POD_DRVR]
'dsk6x11pp.dll' [POD_MODE] 1 [POD_PORT] 0x378 ;[POD_LOG_MAIN]
'pod_main.log' ;[POD_LOG_FUNCTION] 'pod_func.log' ;[POD_LOG_ADAPTER]
'pod_adapt.log' ; ;SCAN PATH "cpu_a" TI320C6711
Which
is the error?
Any help will be appreciated.
Thanks in
advance. _____________________________________ Note: If you do a
simple "reply" with your email client, only the author of this message will
receive your answer. You need to do a
"reply all" if you want your answer to be distributed to the entire group.
_____________________________________ About this discussion
group: