DSPRelated.com
Forums

PLL Control/Status Register

Started by vbehravan February 5, 2005


Hi all,
We develop a TMS320C6713 board. The C6713 code has been tested using
XDS510usb JTAG emulator and everything is O.K.

To finalize our system, we switch to HPI boot loading and load the
C6713 code using HPI.
In the preliminary stages of our code, we initialize the PLL Multiply
Register and PLL control/status register.
As the execution of the code reaches the following line:

*(unsigned volatile int*)PLLCSR = 0x01;

the execution does not proceed correctly.
If this line ignored (commented), the subsequent section of our code
executed correctly BUT OFCOURSE WITH WRONG CLOCK RATE.

Does anyone knows what is the problem?



vbehravan wrote:
>
>
> Hi all,
> We develop a TMS320C6713 board. The C6713 code has been tested using
> XDS510usb JTAG emulator and everything is O.K.
>
> To finalize our system, we switch to HPI boot loading and load the
> C6713 code using HPI.
> In the preliminary stages of our code, we initialize the PLL Multiply
> Register and PLL control/status register.
> As the execution of the code reaches the following line:
>
> *(unsigned volatile int*)PLLCSR = 0x01;
>
> the execution does not proceed correctly.
> If this line ignored (commented), the subsequent section of our code
> executed correctly BUT OFCOURSE WITH WRONG CLOCK RATE.
>
> Does anyone knows what is the problem?
>

Hi,

it's a bit hard to help if you only give one code line :-)

You enable the PLL, but maybe it is not yet stable. Have a look at
spru233c.pdf. If have written some code whtch does the same. I remember
there are two delays after the PLL registers have been set. I don't have
the code at the moment. But the timming should be mentioned in the pll
section of the 6713 data sheet.

HTH

Gustl