Forums

Profiling Code on DSK

Started by Nikhil S. Parvatikar November 24, 2001
Hi !!!
 
When i profile a code on the DSK C6711 ( CCS V2.0) by enabling the profile clock
i find that each assembly instruction takes 6 clock cycles....
 
But when i run the same code on C6x Simulator (CCS V.1.00) i find that each
assembly instruction takes only 1 cycle.........
 
Why is this so & which of these is correct... ???
 
nikhil

--------------------------
Dexcel Electronics Designs (P) Ltd., Bangalore, India