Adolf-
> Yes, that's the way the EMIF works in
asynchronous mode: ARDY is sampled on
> the last programmed strobe cycle. If ARDY is found low, the bus cycle is
> extended until ARDY is high.
>
> >So you're saying the entire HPI read/write cycle is at least 40 + 30
nsec
> >(idle time
> >you mention below), or 70 nsec, not including strobe time?
>
> 10 nsec setup, at least 40ns strobe (depending on ARDY/HRDY), plus 20nsec
> hold.
>
> >You shouldn't have to sync the HPI with anything -- otherwise there
would
> >be a lot of
> >situations where HPI couldn't be used. My guess is that another
combination or
> >sequence of events, yet to be found, will make it unstable again.
>
> That's exactly what I am afraid of. We have used the HPI in several
systems
> before without problems, but these all used slower access time, and never
> had the target DSP been performing so many numerically intense operations.
Are you able to try my suggestion of keeping /CE3 low all of the time; i.e.
/HCS
always asserted? I'm assuming that you can run any type of test software
on the EMIF
side, since the hang-up issue is with combination of hw + sw factors on the HPI
side.
-Jeff
Online · Live + on demand
February 9-11, 2027
Price goes up Jan 1: register now to lock in today's rate
Register Now →
HPI lockup problem
Started by ●June 15, 2007
Reply by ●June 21, 20072007-06-21
Reply by ●June 22, 20072007-06-22
Hi Jeff,
At 10:41 21.06.2007 -0500, Jeff Brower wrote:
>Are you able to try my suggestion of keeping /CE3 low all of the time;
>i.e. /HCS
>always asserted? I'm assuming that you can run any type of test software
>on the EMIF
>side, since the hang-up issue is with combination of hw + sw factors on
>the HPI side.
It is not possible to keep CE3 low all the time, but we did cut the
CE3->HCS connection and tied HCS low: no change.
Meanwhile we have modified the SW on the slave DSP quite a lot, and it
still works stable (after synchronizing both DSPs and increasing the HPI
idle time). We will now concentrate on getting the SW work done and see if
any more problems will occur.
Many thanks for your help and
Best Regards,
Adolf Klemenz
At 10:41 21.06.2007 -0500, Jeff Brower wrote:
>Are you able to try my suggestion of keeping /CE3 low all of the time;
>i.e. /HCS
>always asserted? I'm assuming that you can run any type of test software
>on the EMIF
>side, since the hang-up issue is with combination of hw + sw factors on
>the HPI side.
It is not possible to keep CE3 low all the time, but we did cut the
CE3->HCS connection and tied HCS low: no change.
Meanwhile we have modified the SW on the slave DSP quite a lot, and it
still works stable (after synchronizing both DSPs and increasing the HPI
idle time). We will now concentrate on getting the SW work done and see if
any more problems will occur.
Many thanks for your help and
Best Regards,
Adolf Klemenz







