yunusemrebora, author of unsigned personal email:
Please forward your questions to the c6x group.
See comments below.
On 12/11/07, yunusemrebora wrote:
>
> i have to use emif in my project.i couldnt find emif.h and emif.c or
> emif.obj.actually i want to use c functions to use emif.
You don't need any functions to use the EMIF and you need only a few
lines
of code to configure it for correct operation. The specific configuration
depends on your needs and the hardware configuration - including the
specific type and addresses of your peripheral and the DSP that you are
using.
Look at spru190 in the docs/pdf directory of your CCS installation.
NOTE: If you go to ti.com to get the doc, it will point you to a specific
EMIF document.
so i think i
> have to use this things.may you help me?only i have
to take 8 bit
> digital signal out from emif(ED[31:0]).
Depending on your hardware arrangement, you may be able to do 8 bit
reads/writes or you may have to do 32 bit reads/writes.
mikedunn
i read lots of things but i
> couldnt see c functions and libraries.thank you.
--
www.dsprelated.com/blogs-1/nf/Mike_Dunn.php
